Command and Processes Table - X

For more information on the terms 'Command', 'Process' and 'Macro Command', see Command Table Introduction.

Commands not supported by your product are listed here for contextual purposes only - detailed information about these commands is available from their respective product help files.

Note: if a command is included within your application, you can access more information using the associated link in the right-hand column.

Symbols used in this table:

	- A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required
X	- A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required)
�	- A blue diamond indicates the module is an optional extra for the specified system

Commands - X

Command Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
x-sections-switch	X	X	X		X	X	X	Turn on or off retaining of drive cross-sectional perimeters.
xsec-string-colour	X	X	X		X	X	X	Set colour for drive cross-section strings in underground design.

Processes - X

Process Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
XRUN								Launch a macro.	Process Help
XVALID			X					The process is designed to assist in the selection of parameters for grade estimation, using the cross-validation method.

For Macro commands, see here.